Speaker Placement | Cardas Audio (2024)

Acoustic consultants do not offer free advice, however their input is often well worth the cost. A good one

in our particular corner of the world is Acoustic Sciences Corporation. Howevertherearelikely similar

companiesin your area.

​

Some helpful forums on this topic:

​

https://www.gikacoustics.com/acoustic-advice/

​

https://www.acousticfields.com/acoustics-forum/

​

https://www.audioasylum.com/forums/rives/bbs.html

Very precise speaker placement can open up a whole new dimension in listening, so I will outline the system that is becoming the standard of the industry. This standardized listening room is a Golden Cuboid and is the model for the math used in this system. This method will work with any box speaker, in any reasonably sized rectangular room. You may find that you have already positioned your speakers this way by ear.

Active nodes are the main concern when placing speakers in a rectangular room. A node, or the frequency where speakers and parallel walls interact, is proportional to the speaker to the wall distance.

The three most importance nodes, in order of importance, are proportional to the distance between the speaker and:

1. The side wall nearest the speaker
2. The rear wall
3. The side wall across from the speaker

A secondary factor is the speaker-to-speaker time constant.

When you use this Golden Ratio method to set your room up, the speakers are placed so the three nodes progress or differ from one another in Golden Ratio. This eliminates any unison or near unison resonance in the nodes.

Panel or dipole speakers such as Apogees and Magnepans cancel their side waves, so a formula of .618 x the ceiling height can be used for determining placement from the rear wall. Most box speakers radiate low frequencies in all directions thus a formula that places the speaker to rear wall distance at 1.618 the side wall distance should be used.

Speaker placement, simply stated:

The distance from the center of the woofer face to the side walls is:

Room Width times .276 (RW x .276)

The distance from the center of the woofer face to the wall behind the speaker is:

Room Width times .447 (RW x .447)

This is all you need to know to place speakers in a symmetrical, rectangular room!

​

In the near field position the speakers and the listener’s head are the points of an equilateral triangle. Near field listening gives the perfect stereo field. It is frequently used in the recording studio to position the microphones and the voice in the mix. The near field listening position is determined by the "center to center" distance of the speakers and the distance to the listener’s head. It does not refer to the room in any way.

The importance of symmetrical speaker placement in a small room cannot be over emphasized.

Once the speakers are set as close to perfect as possible, you must angle them slightly toward the listening position. This can be done by ear and usually a ¼ to ½ inch tweek will do. Box speakers generally require a bit more toe-in than planear speakers. You will be able to hear a center focused voice clarify when the sweet spot is hit.

If you are forced to place your speakers on the long side of a symmetrical, rectangular room, create a Golden rectangle in each rear corner. Your speakers can then be placed anywhere along a line extending from the outside rear corner through the inside front corner (Diagram F).

Golden Rectangles, 1.618 from the side walls x 1 from the rear wall, create diagonal lines for speaker placement in a horizontal room.

The Golden Cuboid (Diagram H) is the best "rectangular" shape for a listening room. If, however, you have full architectural freedom, a Golden Trapagon (Diagram I) is by far the favored shape. A Golden Trapagon has a Golden rectangle for the front wall behind the speakers, and the room progresses to a larger (by Golden Ratio in area) Golden rectangle back wall behind the listener.

For example, if the wall behind the speakers is 10 feet x 16 feet, the room would then be 26 feet long and the wall behind the listener would be 13 feet x 21 feet. Ideally, the rear portion of this room would vent into an attic space filled with fiberglass insulation.

The trick to a Golden Trapagon shaped room is it eliminates the problem of parallel walls and the slap and sharp nodes associated with them. The "sound" of this room is a decaying hologram of the original, not a slap. This decay is exponential, or higher, at all frequencies. The relationship between the height and the width of the room, at any point, is Golden Ratio. The cross-section area at the rear of the room is 1.618 times the cross-section of the front. In the example above, the ceiling height would be 12.72 feet.

The ratio of front height or width, to rear height or width, is 1.272 to 1. 1.272 is the square root of 1.618 or Golden Ratio. The progression of size at the ends of the room is a area relationship. The sound confronts the entire surface of the end walls at the same time, rather than progressively as with height and width. It is like tuning a guitar to a major chord, the side walls become the strings and the end walls are the bridge and tailpiece.

As with the information above, these calculators will provide ideal speaker locations,

but do not take into accountfactorssuch asasymmetrical rooms, furniture,

window & door location, or spousal approval. Use the information generated

by these calculators as generalguidance, but realize they may give you

suggested speaker locations that simply aren't feasible in your room.

​

​

If you have further questions, please contact an acoustic consultant.